Single Bus Communications between UPS and Pi (System halt signal) Serial Port (UART) communication with Pi:Ĭompatible with the older version of the V3 UPS communication protocol Support for the PH2.0 4P self-lock switch button with LED Support (no manual intervention, program boot-up)Īfter the outage switch, the UPS automatically switches to dormant mode GPIO power supply interface and UART, halt signal signal interfaceĪbnormal detection of power adapter (power outage time detection)ĭetection of the output voltage value of the USB-A seatĪutomatic notify shutdown before battery depletionĪfter the power failure, the program automatically
TYPE-C Interface (power cord compatible with new Pi4)Įxternal power failure, Pi continuous power supply (no restart) What's new on the Makerfocus RPi UPSPack V3 Plus?
Model Volume (Length x Width x Thickness) UPS board size: length 86.02mm x width 56.02mm x height 10mm (height: measured at the highest protruding position of the component, excluding battery height)īe careful not to buy the wrong battery size, only 4000 mAh battery is smaller than the UPS motherboard, and other capacities are larger than UPS: If you need to solder the headers, please test the basic functions when you receive the product before soldering the headers. It is only needed when the GPIO power supply is needed soldering the 2P pin header, or use the Raspberry Pi serial port to communicate, and only solder the 3PIN pin header when developing new products. Generally speaking, users do not need to solder headers, and only need to connect the power cord to achieve uninterrupted power supply (the external power supply is disconnected, and the battery is uninterrupted power supply, which does not affect the operation of the Raspberry Pi). Added EXT BTN interface to support PH2.0 4P self-locking switch with LED. The new version of UPSPack V3 Plus (V3P) is applicable to the whole series of Raspberry Pi.
0 kommentar(er)
